3-Wire Voltage Mode High-Sensitivity Unipolar Hall-Effect Switch Sensor JYM27111
Product Description – JYM27111 Unipolar Hall-Effect Switch Sensor
The JYM27111 series are high-sensitivity unipolar Hall-effect switch chips designed using advanced BCDMOS process technology. The device integrates on-chip voltage regulator, under-voltage lockout (UVLO), signal amplifier, temperature compensation, offset cancellation, comparator, output driver, and output current-limiting circuitry. Magnetic parameters are minimally affected by mechanical stress, while the chip features excellent EMI immunity and high reliability.
The JYM27111 sensor chip is optimized for industrial environments with a junction temperature range of -40℃ to 150℃ and an operating voltage range of 2.8V to 24V. It is available in TO-92S and SOT23-3L packages, fully compliant with RoHS (EU) 2015/863 standards.
Product Features – JYM27111 Unipolar Hall-Effect Switch Sensor
● 0.18μm BCDMOS Process Technology
● Operating Voltage Range: 2.8V to 24V
● Typical Supply Current: 1.8mA
● High Magnetic Sensitivity: BOP = 25Gs, BRP = 15Gs
● ESD Protection: ±8kV (HBM)
● Junction Temperature Range: -40℃ to 150℃
● Built-in Over-Temperature Protection (OTP)
● VCC-to-GND Reverse Polarity Protection
● Output Current Limiting Protection
● Magnetic switch points stable against supply voltage variation
● Temperature-Compensated Magnetic Switch Points
● Available in TO-92S and SOT23-3L Packages
● RoHS Compliant: (EU)2015/863
Target Applications – JYM27111 Unipolar Hall-Effect Switch Sensor
● Solid-State Switches
● 3-Phase BLDC Motor Commutation Control
● Power Tools
● Flow Sensors
● Tachometers & Speed Measurement
● Speed and Proximity Sensing
● Linear and Angular Position Detection
Ordering Information – JYM27111 Unipolar Hall-Effect Switch Sensor
Package
| Temperature Range
| Ordering Part Number
| Packaging
| Device Code
|
TO-92S
| -40℃～150℃ | JYM27111UA
| Tape and Reel 1000 units | UA |
SOT23-3L
| -40℃～150℃ | JYM27111SO
| Tape and Reel 3000 units | SO
|
Device Marking Example – JYM27111
Functional Block Diagram – JYM27111
Typical Application Circuit – JYM27111
Typical Application Circuit 1: As shown in Figure 1, recommended pull-up resistor RL = 1kΩ ~ 10kΩ, CP = 10nF, CL = 4.7nF.
Typical Application Circuit 2: As shown in Figure 2, for noisy power supply applications, a series resistor R1 is recommended at the VCC pin, with CP between VCC and GND, and CL between OUT and GND, placed close to the device. (Recommended: R1 = 100Ω, CP = 10nF, CL = 4.7nF)
